Foxflash Failed to Read MED17.5 by OBD?
Question:
I can't do MED17.5 TC1766 1.5 mb file with foxflash by obd? any solution?
Solution:
Use bench or boot mode.
Bench mode:
BOSCH MED17.5 [ 1766 ] — VW, Audi, Seat, Skoda [Gasoline]
To read and write use the following driver:
→ BENCH TRICORE
→ VW / AUDI / SEAT / SKODA
→ TC1766 — VAG
→ MED17.5
Boot mode:
BOSCH MED17.5 [ TC1766 INT.F.] — VW, Audi, Seat, Skoda
Step 1: Read and Write ECU
Connect with the multifunction cable the following pinout and the boot shown below.
Use the driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Boot
→ SAK TC1766
If the password error message appears at the beginning of the reading, proceed as follows:
Step 2: Password search
Disable the boot mode by unsoldering the grey wire. Connect the pinout below.
Use the foxflash driver:
→ TOOLS BOOT MODE
→ INFINEON TRICORE Tool Password
→ OBD PASSWORD TPROT V08 VAG
→ Click on "Find Password" and follow the software messages.
Now that the password has been found it's possible to read and write the control unit as described in STEP 1.